{"product_id":"altronix-t2ssk2dq-24v-10a-12v-10a-ptc-16d-s2","title":"Altronix T2SSK2DQ 24V@10A\u002612V@10A\/PTC\/16D\/S2","description":"T2SSK2DQ 24V@10A\u0026amp;12V@10A\/PTC\/16D\/S2\n\nAltronix T2SSK2DQ kit consists of Trove2 enclosure, TSS2 Lenel-S2 (S2 Security Platform)\/\nAltronix backplane with one (1) 24VDC @ 10A power supply\/charger, one (1) 12VDC @ 10A power supply\/charger, two eight PTC protected dual input\/output network\/managed access control modules and two eight PTC protected dual input\/output network\/managed power distribution modules. Also included is a 5-Port hardened switch board. This kit also \naccommodates S2-INST Installation Kit For Lenel-S2 (S2 Security Platform) S2 Network Node for up to sixteen (16) doors in a single enclosure. Trove simplifies board layout and wire management, reduces installation time and labor costs.\n\n\neFlow104NB Power Supply\/Charger - 1\nInput\nVoltage: 120VAC, 60Hz, 4.5A max.\nInput Fuse: 6.3A \/ 250V.\n\nOutput\nVoltage: 24VDC @ 10A.\nAuxiliary: 1A (unswitched).\nProtection: Overvoltage protection. Filtered and regulated.\n\n\neFlow102NB Power Supply\/Charger - 2\nInput\nVoltage: 120VAC, 60Hz, 3.5A max.\nInput Fuse: 5A \/ 250V.\n\nOutput\nVoltage: 12VDC @ 10A.\nAuxiliary: 1A (unswitched).\nProtection: Overvoltage protection. Filtered and regulated.\n\n\nBoth Power Supplies\nBattery Charging\nCapacity: 12VDC\/12AH (2 within enclosure); 40AH\/65AH (requires separate enclosure)\nType: Sealed lead acid or gel type\nFailover: Upon AC loss, instantaneous\n\u003ci\u003e(Batteries are sold separately).\u003c\/i\u003e\n\nFire Alarm Disconnect\nSupervised: Latching or non-latching.\nEOL 10K Resistor.\n\nSupervision\nAC Failure: Form “C” contacts.\nBattery: Form “C” contacts.\nLow DC Power Shutdown: Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.\n\nIndicators LED\nAC Input: 120VAC is present.\nDC Output: Powered.\nBattery: Discharged or not connected.\n\n\nTwo (2) LINQ8PDCB Network Power Distribution Modules\nInput\nVoltage: 24VDC from eFlow104NB and 12VDC from eFlow102NB\nInput PTCs 9A.\n\nOutputs\nPTC protected auto-resettable outputs.\nAny of the eight (8) PTC protected power outputs are selectable to follow power Input 1 or Input 2\nIndividual outputs may be set to OFF position for servicing\n\nOutput PTCs:\n2.5A\n\nStatus Monitoring\nPower Supply output voltage and load, Voltage and load of each output\nFACP trigger and reset status, Unit temperature (Celsius)\nPower Supply AC and Battery status, Battery health\n\nReporting:\nWindows Dashboard Alert messages\nE-mail notifications, Event Log tracks history\n\nIndicators (LED)\nBat Local: Charging current status\nFACP: Triggered \/ Released\nInput: Input signal\nOut1 - Out8: Output status\n\n\nTwo (2) LINQ8ACMCB Networked Access Power Controllers\nInput\nVoltage 24VDC from eFlow104NB and 12VDC from eFlow102NB\nInput PTC: 9A\n\nOutputs\nPTC protected auto-resettable outputs\nAny of the eight (8) PTC protected power outputs are selectable to follow power Input 1 or Input 2\nIndividual outputs may be set to OFF position for servicing\n\nOutput PTCs:\n2.5A\n\n\nProgramming Features:\nEight (8) Programmable Outputs:\n- Fail-safe, fail-secure or auxiliary outputs\n- Input controlled or manually controlled through software\n- High (over) and low (under) voltage and current monitoring by output\n- Multiple outputs may be programmed to be triggered by a single input\n- Battery back-up by output\n\nEight (8) Programmable Trigger Inputs:\n- Normally open (NO), Normally closed (NC) or Open collector sink inputs\n- Wet Input (5VDC - 24VDC) with 10k resistor\n- Any combination of the above\n\nOther Programmable Trigger Inputs:\n- Monitor power supply(ies) input for voltage and current limits (high\/low)\n- Input and output current calibration, Programmable timer events\n- Programmable user levels, Enable or disable alerts by type\n- Programmable alert reporting delay\n\nIndicators (LED)\nGreen AC LED: indicates AC trouble condition\nGreen BAT LED: indicates battery trouble condition\nGreen FACP LED: indicates FACP disconnect is triggered\nFlashing Blue Heartbeat LED: indicates network connection\nIndividual OUT1 - OUT8 Red LEDs: indicate outputs are triggered\nIndividual Voltage LEDs: indicate 12VDC (Green) or 24VDC (Red)\n\n\nNetWay5B 5-Port Hardened Switch\nInput\n24VDC, current draw: 150mA\n\nEthernet Ports:\nFive (5) 10\/100\/1000 Mbps ports.\nConnectivity: RJ45, auto-crossover.\nWire type: 4-pair CAT5 or better structured cable.\nDistance: up to 100m.\nSpeed: 10\/100\/1000 Mbps, half\/full duplex, auto negotiation.\n\nIndicators (LED)\nIndividual PoE On LEDs for each port.\nIndividual IP Link status, 10\/100Base-T\/active LEDs for each port.\n\n\nEnvironmental\nTemperature\nOperating: 0° C to 49° C (32° F to 120° F).\nStorage: - 20° C to 70° C ( - 4° F to 158° F).\n\nRelative Humidity\nRelative Humidity: 85%  +\/- 5%.\n\nBTU\/Hr. (approx.):\n196 BTU\/Hr.","brand":"Altronix","offers":[{"title":"Default Title","offer_id":46151444398276,"sku":"T2SSK2DQ","price":2370.72,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0712\/2649\/1076\/files\/main_c3ed6c76-3b05-46ea-a009-1e3e8239cb7f.jpg?v=1778870972","url":"https:\/\/avdepot.net\/products\/altronix-t2ssk2dq-24v-10a-12v-10a-ptc-16d-s2","provider":"AV Depot","version":"1.0","type":"link"}